COMPONENTS
AC Source
Thyristor
Gate Pulse
Resistor
Ammeter
Voltmeter
Ground
OBSERVATION TABLE
| S.No. | VLrms (V) |
ILrms (A) |
VLavg (V) |
ILavg (A) |
|---|---|---|---|---|
6
7
VT1
1
2
AC1
3
4
5
THY1
23
24
IL
8
GP1
9
10
VGP1
17
18
VT2
11
GND1
12
13
AC2
14
15
16
THY2
43
44
R
19
GP2
20
21
VGP2
45
46
VLOAD
34
35
VT3
22
GND2
25
26
AC3
36
37
38
THY3
27
28
VR
29
30
VY
31
32
VB
39
GP3
40
41
VGP3
42
GND3
33
GND4
WAVEFORM
- STEP 1: Drag and drop the components in the workspace to create the circuit.
- Nos of required components:
- AC Source – 3, Thyristor – 3, Gate Pulse - 3, Resistor - 1
- Voltmeter – 10, Ammeter - 1, Ground – 4
- STEP 2: Make the connections as per the instructions given below:
- (a) (01-12, 12-25, 02-03, 03-06, 04-07, 05-08)
- (b) (08-09, 10-11, 04-23, 24-43, 13-14, 14-17)
- (c) (15-18, 15-23, 16-19, 19-20, 21-22, 26-36)
- (d) (34-36, 35-37, 37-23, 02-27, 13-29, 26-31)
- (e) (25-33, 28-33, 30-33, 32-33, 38-39, 39-40)
- (f) (41-42, 44-32, 24-45, 46-32)
- Note: Click on the wire to delete the connection.
- STEP 3: Click on the CHECK button to check the connections.
- Note: Right click on the component to open the dialog box to edit the properties of the component.
- STEP 4: Input the values for all the required components (AC Sources, Gate Pulses and Resistor) and the waveform will get plot automatically.
- STEP 5: Now, Click on the ADD button to insert the reading into the observation table.
- STEP 6: Now, you can input different values as per your requirement to get the desired waveform.
- STEP 7: Repeat Step 5 to again insert the reading into the table and now repeat Steps 6 to 7 to take more readings.
- STEP 8: Click on the PRINT button to take out the print of the webpage.
- STEP 9: Click on the RESET button to reload the webpage.
